Dual Control Arm
For all models of Beech aircraft with a center control column.
Cygnet Part #: CA35-221
See prices page for Special Package pricing
The Cygnet Aerospace Dual Control Assembly is a 100% new FAA-PMA
approved universal design. Our one part fits all 56 Beech aircraft models with
the center control column.
Our Dual Control Assembly was designed by an award winning engineer with 25 years
in aircraft and high technology design. During the control's approval
process, the FAA deemed the functionality and design were so similar to the
Beech part, an STC
was not required thus making this a direct replacement
Your existing Aileron Trim can almost always be removed and reused from your single
to your dual control, and we recommend you do this.
Click here for complete instructions on how to remove your Aileron Trim.
The Dual Control Assembly can be installed either "Vee" up or "Vee" down in the single engine aircraft,
and "Vee" up on the twins. Mounting holes are located in the top and bottom center of the
control housing. These are threaded for #10-32 screws and are intended for the Cygnet
Flight Desk (Chart-Holder).
Average basic installation time is only one hour. Additional components such as push-to-talk
circuitry, map lighting, clocks, and new auto pilot and trim controls will increase
installation time. Consult your avionics / maintenance personnel for an exact time estimate.
The Dual Control Assembly retains the same configuration and appearance as the factory model, but
the design is much improved. Easily removable access panels allow for easy
chain lubrication, inspection and maintenance.
The Cygnet Dual Control Assembly eliminates Airworthiness Directives
AD 62-08-03 R1 and
AD 71-24-10 R1 on Beech yokes.